Olympus OEP-4 Instructions Manual page 67

Irregularity Possible cause
Remote control from the The remote cable is connected improperly.
connected equipment is not
available.
The remote cable is broken.
The remote cable is subjected to an excessive
force.
The endoscope or scope cable is not connected. Connect the endoscope or scope cable as described in the
The connected equipment is turned OFF.
This instrument is turned OFF.
The connected equipment is set improperly.
The function of the REMOTE 2 terminal is set
improperly.
The communication speed (BAUDRATE) is set
improperly (for RS-232C communication).
A communication problem has occurred
between this instrument and the connected
equipment.
The CVP counter is not The remote cable is connected improperly.
displayed.
The remote cable is broken.
The remote cable is subjected to an excessive
force.
The connected equipment is turned OFF.
This instrument is turned OFF.
The connected equipment is set improperly.
The communication rate (BAUDRATE) is set
improperly.
A trouble occurred in the communication with
the connected equipment.
The video system center is remove data mode. Remove data mode is cancelled with reference to the
Solution
Connect it properly as described in "Chapter 2
Installation and Connection" in "INSTRUCTIONS
(BASIC)" or "Chapter 2 Installation and Connection" on
page 15 in "INSTRUCTIONS (ADVANCED)."
Replace the new remote cable.
Change the cable layout to remove the excessive force.
instruction manual for the connected equipment.
Turn the connected equipment ON as described in its
instruction manual.
Turn this instrument ON.
Set the connected equipment properly as described in
"3.1 Setup of Connected Equipment" on page 25, or in
"3.3 Setup of Connected Equipment" in
"INSTRUCTIONS (BASIC)."
Set it properly as described in "Setting "RM2 FUNC"" on
page 61 and in the instruction manual of the connected
equipment.
Set it properly as described in "Setting "BAUDRATE""
on page 59 and in the instruction manual of the connected
equipment.
Turn this instrument OFF, then ON again.
Turn the connected equipment OFF, then ON again.
Connect it properly as described in "Chapter 2
Installation and Connection" in "INSTRUCTIONS
(BASIC)" or "Chapter 2 Installation and Connection" on
page 15 in "INSTRUCTIONS (ADVANCED)."
Replace the new remote cable.
Change the cable layout to remove the excessive force.
Turn the connected equipment ON as described in the
instruction manual.
Turn this instrument ON.
Set it properly as described in "3.3 Setup of the
Connected Equipment" in "INSTRUCTIONS (BASIC)"
or "3.1 Setup of Connected Equipment" on page 25 in
"INSTRUCTIONS (ADVANCED)."
Set it properly as described in the description on "Setting
"BAUDRATE"" on page 59 as well as the instruction
manual for the connected equipment.
Turn this instrument OFF then ON again.
Turn the connected equipment OFF then ON again.
instructions manual of the video system center.
7.1 Troubleshooting Guide
7
67