Olympus OEP-4 Instructions Manual page 50

2
Press "b" or "B" to select either "RGB" or
"YPbPr."
The selected setting is displayed in green on the
monitor.
RGB : The RGB component video signals
YCbCr : The color-difference video signals
Setting "SD SYNC(IN)"
This item is used to select the sync signal when the
SDTV signal is used as the input video signal to this
instrument.
1
Press "v" or "V" to move the cursor on "SD
SYNC(IN)."
Characters "SD SYNC(IN)" are displayed in green
when the cursor is positioned on this item.
2
Press "b" or "B" button to select either "G-ON" or
"EXT."
The selected setting is displayed in green on the
monitor.
G-ON : The sync-on-green type video signals
EXT : The sync separation type video signals
5
Setting "HUE"
This item is used to adjust the hue of the printed picture
when the composite video or S-Video signal is used as
the input video signal to this instrument.
Setting a positive value makes the image purplish and
setting a negative value makes it greenish.
It cannot be set up, if "COMPONENT" is selected in
"Setting "INPUT SEL"" on page 49.
1
Press "v" or "V" to move the cursor on "HUE."
Characters "HUE" are displayed in green when the
cursor is positioned on this item.
2
Press "b" or "B" to select between "–14" and "14."
The selected setting value is displayed in green on
the monitor.
Setting "COLOR"
This item is used to adjust the color depth of the printed
picture when the composite video or S-video signal is
input to this instrument.
Setting a positive value makes the image colors dense
and setting a negative value makes them less dense.
Setting "OFF" reproduces the images in black and
white.
1
Press "v" or "V" to move the cursor on "COLOR."
Characters "COLOR" are displayed in green when
the cursor is positioned on this item.
50
5.8 Setup of the INPUT SETUP Menu
2
Press "b" or "B" to select between "–13" and "14"
or "OFF."
The selected setting value is displayed in green on
the monitor.
Setting "GAIN"
This item is used to adjust the contrast of the printed
picture when the composite video or S-video signal is
input to this instrument.
Setting a positive value enhances the contrast and setting
a negative value attenuates it.
1
Press "v" or "V" to move the cursor on "GAIN."
Characters "GAIN" are displayed in green when
the cursor is positioned on this item.
2
Press "b" or "B" to select between "–14" and "14."
The selected setting value is displayed in green on
the monitor.
Setting "OFFSET"
This item is used to adjust the brightness of the printed
image when the composite video or S-video signal is
input to this instrument.
Setting a positive value makes the image brighter and
setting a negative value makes it darker.
When "INPUT SEL" is set to "COMPONENT" in
"Setting "INPUT SEL"" on page 49, you cannot set the
value to anything less than 0 (minus direction).
1
Press "v" or "V" to move the cursor on "OFFSET."
Characters "OFFSET" are displayed in green when
the cursor is positioned on this item.
2
Press "b" or "B" to select between "–14" and "14."
The selected setting value is displayed in green on
the monitor.