Setup Of This Instrument - Olympus OEP-5 Instructions Manual

3.5 Setup of This
Instrument
The procedures in this section describe basic operation
when used with the EVIS EXERA II video system
center (CV-180).
For other setups of this instrument, set them as desired
by "Chapter 5 System Setup" in "INSTRUCTIONS
(ADVANCED)."
MENU button
LCD panel
3
1
Press the "MENU" button.
2
Depending on the connected equipment, perform
setup of the color video printer (OEP-5) by
following the procedures below.
Table 3.4
Connecting
CV-180
22

3.5 Setup of This Instrument

Cursor keys
"v" "V" "b" "B"
ENTER button
Figure 3.18
Procedure
1 Press "v" or "V" until the LCD
panel shows "SIGNAL SETUP,"
and press the "ENTER" button.
2 When "INPUT SETUP" appears,
press "v" or "V" to display
"INPUT SEL," and press the
"ENTER" button.
3 Press "v" or "V" until
"COMPONENT" appears below
"INPUT SEL," and press the
"ENTER" button.
4 Press the "MENU" button. Press
"v" or "V" until "SIGNAL
SETUP" appears on the LCD panel,
and press the "ENTER" button.
5 When "INPUT SETUP" appears,
press "v" or "V" to display "SD/
HD SEL," and press the "ENTER"
button.
6 Press "v" or "V" until "AUTO"
appears below "SD/HD SEL," and
press the "ENTER" button.