Moving The Pointer; Printing - Olympus OEP-4 Instructions Manual

2
Confirm that the Source/Memory display shows
"M." If not, press the SOURCE/MEMORY button
until "M" is displayed.
The Source/Memory display "M" indicates that the
memory image is being displayed (see Figure 4.11).
The Source/Memory display "S" indicates that the
source image is being displayed.
Monitor
LCD panel
Figure 4.11

Moving the Pointer

The pointer in which the memory position storing a
picture is movable.
1
Press "v," "V," "b," or "B" while normal screen is
displayed to move the cursor.
Pressing "v," "V," "b," or "B" while normal screen
is displayed moves a pointer in the same direction
as the direction which a cursor keys shows.

Printing

Print the images captured as follows.
CAUTION
• Do not turn OFF or take out the paper tray while
printing is in progress. Otherwise, paper jam and/or
malfunction may result.
• Do not open the front door or take out the paper tray
while printing is in progress. Otherwise, paper jam
and/or malfunction may result.
Source/Memory display
Source/Memory display
• Do not leave 10 or more print sheets on the paper exit.
Otherwise, paper jam may result. Also, even when the
number of print sheets is less than 10, message
"REMOVE PRINTS" may be displayed on the
monitor and LCD panel and printing is interrupted
depending on the print sheet conditions. If this occurs,
remove the print sheets from the paper exit. Printing
will resume automatically.
• If you turn OFF this instrument while the PRINT lamp
is lit, the ink ribbon quantity displayed on the
remaining ink ribbon display on the LCD display and/
or the monitor may not match the actual ink ribbon
quantity remaining.
Be sure to turn this instrument OFF after printing is
completed and the PRINT lamp turns off.
NOTE
• If paper jam occurs while printing is in progress, take
measures refer to "4.3 In the Case of Paper Jam" for
"INSTRUCTIONS (BASIC)."
• You cannot store the image in the memory page that is
printing in progress or reserved for printing. Wait until
the printing completes.
• If you open the front door during printing, printing is
interrupted. If you close the front door, the print sheet
being printed is ejected. To print again, press the
PRINT button.
• When the remaining print sheets in the paper tray
decreases, a rattling sound may be heard during
printing. This is not a malfunction.
• Depending on the environment in which this
instrument is used or on the condition of the print
sheets, the printed sheets output on the paper exit may
go over the stopper and drop from the paper exit.
Printed sheets may slide between previously ejected
print sheets, and may not stack up in the printed order.
1
Press the PRINT button.
The image(s) in the currently selected memory
page will be printed out (see Figure 4.12).
Figure 4.12
4.2 Control From the Front Panel
4
PRINT button
33