Reference Manual
00809-0200-4648
2.7.2
Join device to network
Fast key
To communicate with the Wireless Gateway, and ultimately the host system, the
transmitter must be configured to communicate over the wireless network. This step is
the wireless equivalent of connecting wires from a transmitter to the host system.
Procedure
1. From the Home screen, select 2: Configure.
2. Select 1: Guided Setup.
3. Select 2: Join to Network.
4. Using a Field Communicator or AMS Device Manager to communicate with the
Note
If the Network ID and Join Key are not identical to those set in the Gateway, the
transmitter will not communicate with the network. The Network ID and Join Key may be
obtained from the Wireless Gateway on the System Settings → Network → etwork
Settings page of the Wireless Gateway web based user interface.
Figure 2-11: Wireless Gateway Network Settings Page
Rosemount 648 Wireless
transmitter, enter the Network ID and Join Key so they match the Network ID and
Join Key of the Wireless Gateway and the other devices in the network.
2, 1, 2
Configuration
May 2020
21