Emerson Rosemount 648 Reference Manual page 2

Safety messages
Rosemount 648 Wireless Hardware Revision
®
HART Device Revision
Device Install Kit/DD Revision
NOTICE
Read this manual before working with the product. For personal and system safety, and for optimum product performance, make
sure to thoroughly understand the contents before installing, using, or maintaining this product
For technical assistance. contacts are listed below:
Customer Central
Technical support, quoting, and order related questions.
United States:
Asia Pacific:
Europe/Middle East/Africa:
North American Response Center
Equipment service needs
1-800-654-7768 (24 hours - includes Canada)
Outside of these areas, contact your local Emerson representative.
The Rosemount 648 Wireless and all other wireless devices should be installed only after the Wireless Gateway has been installed
and is functioning properly. Wireless devices should also be powered up in order of proximity from the Wireless Gateway,
beginning with the closest. This will result in a simpler and faster network installation.
Shipping considerations for wireless products (lithium batteries: Black Power Module, model number 701PBKKF):
The unit was shipped to you without the power module installed. Remove the power module prior to shipping the unit. Each Black
Power Module contains two "C" size primary lithium-thionyl chloride battery. Primary lithium batteries are regulated in
transportation by the U. S. Department of Transportation, and are also covered by IATA (International Air Transport Association),
ICAO (International Civil Aviation Organization), and ARD (European Ground Transportation of Dangerous Goods). It is the
responsibility of the shipper to ensure compliance with these or any other local requirements. Consult current regulations and
requirements before shipping.
Power Module Considerations (Black Power Module, model number 701PBKKF):
The Black Power Module with the wireless unit contains two "C" size primary lithium-thionyl chloride battery (model number
701PGNKF). Each battery contains approximately 2.5 grams of lithium, for a total of 5 grams in each pack. Under normal
conditions, the battery materials are self-contained and are not reactive as long as the batteries and the pack integrity are
maintained. Care should be taken to prevent thermal, electrical or mechanical damage. Contacts should be protected to prevent
premature discharge. Battery hazards remain when cells are discharged. Power modules should be stored in a clean and dry area.
For maximum power module life, storage temperature should not exceed 30 °C.
CAUTION
The products described in this document are NOT designed for nuclear-qualified applications.
Using non-nuclear qualified products in applications that require nuclear-qualified hardware or products may cause inaccurate
readings.
For information on Rosemount nuclear-qualified products, contact a Emerson Sales Representative.
WARNING
Follow instructions
Failure to follow these installation guidelines could result in death or serious injury.
Ensure only qualified personnel perform the installation.
2
1
4
Device Revision 4, DD Revision 1 or higher
1-800-999-9307 (7:00 a.m. to 7:00 p.m. CST)
65 777 8211
49 (8153) 9390