Installing A Flash Memory Card - Cisco 7600 Series Manual

Chapter 3 Installing and Configuring Route Switch Processors and Supervisor Engines
Table 3-3
and route switch processors.
Table 3-3
Product Number
RSP720 and RSP720-10GE Flash Memory Cards
MEM-RSP720-CF256M
MEM-RSP720-CF512M
MEM-RSP720-CF1G
Sup720 and Sup32 Flash Memory Cards
MEM-C6K-CPTFL64M
MEM-C6K-CPTFL128M
MEM-C6K-CPTFL256M
MEM-C6K-CPTFL512M
Sup2 Flash Memory Cards
MEM-C6K-ATA-1-64M

Installing a Flash Memory Card

To install a flash memory card, follow these steps:
Hold the memory card with the connector end of the card toward the slot. The connector end of the card is
Step 1
opposite the end with the write-protection switch (if there is one), which is shown in
Slide the card into the slot until the device completely seats in the connector at the back of the slot and
Step 2
the ejector button pops out toward you.
Do not attempt to force the memory card fully into the slot or you could damage the connector pins.
Caution
When correctly inserted, a portion of the device remains outside the slot.
Step 3 Format the memory card the first time that it is installed in the system.
Be sure to format the memory card with the type of supervisor engine or route switch processor that the
Note
card is being used with. A memory card formatted for one type of supervisor engine or route switch
processor may not work with another type.
OL-10100-04
lists the Cisco product numbers of memory cards supported on Cisco 7600 supervisor engines
CompactFlash Memory Cards
Description
Cisco CompactFlash Memory Card, 256 MB
Cisco CompactFlash Memory Card, 512 MB
Cisco CompactFlash Memory Card, 1 GB
Cisco CompactFlash Memory Card, 64 MB
Cisco CompactFlash Memory Card, 128 MB
Cisco CompactFlash Memory Card, 256 MB
Cisco CompactFlash Memory Card, 512 MB
Cisco ATA Type 1 Flash Memory Card, 64 MB
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
Using Flash Memory Cards
Figure 3-5.
3-13