Install The Compactflash Memory Card; Remove And Install The Flash Memory Card - Cisco 4451 ISR Hardware Installation Manual

Chapter 6 Install and Upgrade Internal Modules and FRUs
Step 6
Press the ejector button again. This ejects the CompactFlash memory card partially out of its slot.
Step 7
Pull the CF memory card out of its slot.
Step 8
Push the ejector button in until the button is flush with the bezel.
Caution
To prevent damage to the ejector mechanism, the ejector button must remain pressed all the way in (flush
against the bezel) when not being used to eject a CompactFlash memory card.
Step 9
Replace the fan tray and then the bezel.

Install the CompactFlash Memory Card

To install a CompactFlash memory card:
Step 1
Read the
module.
Step 2
Remove the fan tray. For instructions on removing the fan tray, see
page
Step 3
Make sure that the ejector button is fully seated until it is flush with the bezel.
Note
Step 4
Insert the CompactFlash memory card into the slot until it is fully seated. The ejector button remains
flush with the panel.
Note
Caution
To prevent damage to the ejector mechanism, the ejector button must remain fully seated when not being
used to eject a CompactFlash memory card.
Step 5
Replace the CompactFlash cover by inserting the cover lip into the chassis and pushing the cover to snap
it back into place.
Step 6
Replace the fan tray.

Remove and Install the Flash Memory Card

This section describes installing and replacing flash memory cards in the router. It contains the following
sections:
OL-32185-02
"Safety Warnings" section on page 6-2
6-58.
If the ejector button is projecting out from the panel, push it in until it is flush with the bezel.
If the ejector button is projecting from the panel after you insert the CompactFlash memory card,
remove the CompactFlash memory card, press the ejector button until it clicks, and reinsert the
CompactFlash memory card.
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Remove and Install the Flash Memory Card
and disconnect the power supply before you replace any
"Replace Fan Tray" section on
6-65