About The Fc Hba Port Configurations; About The 2-Port 8 Gb Fc Hba - VERITAS NetBackup 5230 Appliance Product Description

About the FC HBA port configurations

About the 2-port 8 Gb FC HBA

For complete information about FC HBA card usage, see the NetBackup Appliance
Fibre Channel Guide.
See "About the FC HBA port configurations"
The NetBackup 5230 appliance add-in cards are available in five configurations.
Several configurations include one FC HBA card for VMware, Optimized
Deduplication over FC, or tape library connectivity.
Configurations D and E support FTMS. In these configurations Port 1 on each FC
HBA card (1) in slots 5 and 6 are configured in Target mode by default when SAN
Client Fibre Transport is enabled. Port 2 in slots 5 and 6 and all of the other FC
ports are configured in Initiator mode.
All configurations support the appliance to work as a replication target for Optimized
Duplication and Auto Image Replication. For more information about available HBA
cards for target port use, refer to the NetBackup Appliance Fibre Channel Guide.
FC HBA card target and initiator ports
Figure 1-6
See "About the NetBackup 5230 rear panel configurations"
The Fiber Channel (FC) ports connect the appliance to clients or other devices for
Fibre Transport data transfer.
Dimensions - 2.54 in x 6.6 in (6.4516 cm to 16.764 cm) (low-profile)
Power consumption - Typical: 6.2 watts at 0°C to 55°C (32°F to 131°F)
Operating temperature - 0°C to 55°C
Storage temperature - -40°C to +70°C (-40°F to +158°F)
Storage humidity - 10% RH to 90% RH (operating, non-condensing) and 5% RH
to 93% RH (non-operating, non-condensing)
Product overview
About the FC HBA port configurations
on page 18.
on page 16.
18