VERITAS NetBackup 5230 Appliance Product Description page 13

Rear panel connectors and features
Table 1-3
Number Function
1, 2 Power Supply Modules #1, #2 (120VAC)
3 NIC1/eth0, a 1Gb connector that is reserved for private management usage
By default, NIC1 (eth0) is factory set to IP address 192.168.229.233. This private
network address is reserved to provide a direct connection from a laptop to perform
the initial configuration of the appliance. NIC1 (eth0) is typically not connected to
your network environment.
After you complete the initial configuration, you can connect NIC1 (eth0) to an
administrative network that does not provide any backup data transfer.
4, 5, 6 NIC2/eth1, NIC3/eth2, and NIC4/eth3, reserved for public networks. All three are
1Gb connectors.
7 DB-15 VGA connector
8 RJ45 Serial-A port (reserved)
9 USB connectors
10 IPMI remote management port
11 NIC5/eth4 and NIC6/eth5, left to right: 10Gb network connectors for public networks
12 Add-in PCIe adapter slots (SAS, Fibre Channel, 10Gb Ethernet)
13 Serial-B port (reserved)
Starting in January 2014 NetBackup appliances may include grounding studs in
case your lab environment has such a requirement. The studs are located on the
rear panel of the appliance. You can use standard grounding practices to connect
grounding wires to the studs.
Appliance grounding studs
Figure 1-2
The serial number is located on a vertical bar in the rear panel of the appliance.
Product overview
About the appliance rear panel
13