Mass-Production Mode - Dataman 48UXP User Manual

such a function since the A9 location do not standardize for
chip over 40 pin, using such a function may damage the chip
since a 12V high voltage will applied to the chip and cause the
damage of the chip by accident.

Mass-production Mode

Menu
The Dataman-48UXP can be use as a mass-production
programmer for manufacturing. When enter mass production
mode, all keyboard and mouse functions are disabled. The
operator needs only to insert the chip into the ZIF socket, wait
until the green LED next to the socket flash, remove the
programmed chip and insert new chip. Anyone can do the job
well without special training or skills. Since all keyboard and
mouse functions are disabled, the possibility of errors being
caused by pressing the wrong keys or changing the buffer's
contents are eliminated.
In mass production mode, the Dataman-48UXP first performs
an insertion test and an ID check on newly inserted chip. It
then automatically programs the chip.
Note:
The insertion test must be enabled in operation option
set up in mass-production mode to ensure yield rate of
programming.
Necessary set up in mass production mode.
After enter mass production mode a series screen will display
and asking the user to fill the set up and confirm it, first you
need to fill the operation set up menu (for operation set up,
please reference to the device operation option section) then
configuration set up menu (this configuration set up menu is
device specific, only chip with configuration register has this
Device / Mass Produce