Function Test - Dataman 48UXP User Manual

will automatically program the main memory and program the
configuration byte in a single command (program or mass
production mode program).
Special
configuration/ memory protect
Press this key do not means the chip will be memory protect
(protect or secure the chip from read), if in device
configuration menu the chip do not enable the lock bit or
protect enable, this commend really means is to write the
configuration into the chip.
Function Test (only available for logic chip)
Menu Device/ Function test
Hot key Alt-T
This function only available when a logical device has been selected
it applied the test vector to the device and compare the outputs with
the expected outputs. It tests if the logical chip has been
programmed correctly after the chip has been secured and the fuse
map is not readable again. It displays a message indicating success
or failure, once failure it display the vector number and which pin is
not match the expect result.
Before perform memory test, you can modify the vector and set up
the options operation screen.
First Enable the function test or function test after secure
in options.
Second Select the function test voltage with twice or once.
Third Define the "X" don't care state in the vector;
High/Low or high impedance
note for program