Led Display; File Commands; Save Buffer To File - Dataman 48UXP User Manual

LED Display

The Dataman-48UXP has a three LED display to indicate the
status of the socket. Read this section carefully to avoid damage to
chips.
Warning: Do not insert or remove a chip from a
socket while the yellow LED is on (Busy)!
Green LED on (Good)
Yellow LED on (Busy)
Red LED on (Error)
Flashing LED, 5Hz frequency. This only applies to mass production
mode, the chip pass the program and verify cycle and waiting for
operator to remove the chip and insert a new chip.

File Commands

Save Buffer to File

Menu
Hot key
This option is used to save the memory buffer to a file on the
hard disk. Select a file (to overwrite!) using the mouse, or type
the file name in the box provided. You can also type in a file
spec. (e.g. *.hex) at the Name prompt. This will display all the
files of the specified type, and you can then select the required
file to overwrite.
The last operation result passed.
The socket is busy; do not remove or
insert the chip on the ZIF socket
before green LED or red LED on.
The last operation resulted in failure.
File / Save Buffer
Alt-S