Dataman 48UXP User Manual page 70

have selected an incorrect device as active device, or the device is
an older/newer version than the device supported by the
Dataman-48UXP.
Select the correct device as active device. If the error still occurs,
download the latest release of software from our web. If you are
sure that the device you are using uses the same programming
algorithm as a device that is supported, you can use device as active
device. You can then disable device code checking by setting the
Operating Options.
No device on socket!
The Dataman-48UXP does not detect a device in the socket.
The inserted device may be damaged. Replace it with a similar
device and try again.
No test version in the buffer!
The memory buffer does not contain any test vectors. When the
Dataman-48UXP tries to verify/function test a PLD, is displays this
message.
Download a file that contains test vectors before doing a function
test. Test vectors are usually included in JEDEC files.
Not enough memory available to complete operation!
There isn't enough memory available to complete the requested
operation. Free some memory and retry the operation.
Over current detected!
A current higher than expected was found. This might indicate that
the device has been damaged or is short-circuit.
Check the socket or replace the device.