Table of Contents
Advertisement
ASCII Decimal Hex format example
0,1,2,3,4,5,6,7,8,9,10,11,12,13,14,15,16,17, ...
Modulo-26 format example
A,B,C,D,E,F, ... ,Z,AA,AB,AC, ....
Insertion Test
This option performs the device-insertion check of the
chips in the sockets. The insertion check includes poor pin
contact, pin count mismatch (the pin count of the chip
designated in the software does not match the pin count of
the actual chip in the socket), device in wrong position,
device upside-down; short-circuit between pins, and chip
damage. Result is displayed at the socket's LED.
Device ID Check
This option performs a device signature and manufacturer match test. With the chip
selected and plugged into a socket, Dataman-48UXP checks the device ID and displays
the results of each check on the LED display.
Verify Passes
Checking this option will instruct the Dataman-48UXP to perform device verification
with the buffer data when programming is complete. When verify passes is enabled,
one of the three verify options (as described below) must be set.
Verifying Options
The following three options are available for
verification of data retention following programming:
verify twice with V
10% , and verify once with V
only be enabled if the 'Verify passes' option (see
above) is enabled.
± ± ± ± 5%, verify twice with V
cc
. These options will
cc
± ± ± ±
cc
Advertisement
Table of Contents
