Table of Contents
Advertisement
Read operation (Hot Key ALT-R), you can transfer the chip's
contents into the buffer.
4)
Insert blank chip of the same type into the ZIF sockets, set the
device operation option (Hot Key F4, detail of device option,
reference to chapter 4 of this manual) then press program (Hot
Key ALT-P).
5)
To speed up throughput, user can change the mode to Mass
production mode (move the mouse to device, click the left key
of mouse moving the cursor to mass production mode and click
the left key of mouse again). After entering this mode, the
Dataman-48UXP will program chips automatically after the
chip
has
properly
Dataman-48UXP.
6)
If the chip has configuration byte for set up the oscillator type,
watch dog, code protect, etc in the chip. User need to enable
the configuration (Hot Key ALT-G) then edit the desired set up
in
to the configuration
protect/program configuration in the SW to program the
configuration byte of the chip, the configuration menu only
available if the chip has this specific function.
7)
Program the configuration byte or protect the chip can also be
done in single key press or in mass production mode without
need to press the memory protect separately, to achieve this
user need to enable the memory protect in the device operation
menu first then after perform program, the programmer will
program the main buffer then program the configuration byte
or protect the chip in sequence. For chip has memory protect
function, after the code protect bit been set and perform protect,
the chip will not allow to read back again and can not verify
too.
8)
For a detailed explanation of the device operation options,
please refer to Chapter 3 and 4.
inserted
into
the
byte,
then
socket
of
the
perform
memory
Advertisement
Table of Contents
