Fujitsu ETERNUS AF250 S2 Basic Operation Manual page 56

5. Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any space
between them.
Plate
M5 screw
The M5 screw positions for the rack rails are determined by the drive enclosure base line.
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in the
2nd and 5th holes on the rear rack pillars above the base line to fasten the rack rails.
Sixth screw
(M5 screw)
First screw
(M5 screw)
Fifth screw
(M5 screw)
Second screw
(M5 screw)
(3)
Tighten the M4 screws of the rack rails that were slightly unscrewed in
(4)
Install the drive enclosure in the rack.
Rack rail (left)
Plate
(Front view of rack pillar)
M5 screw
Front view of drive enclosure
[Left]
2U
Bottom position of
drive enclosure
Rack rail
Rear view of drive enclosure
[Left]
2U
Bottom position of
drive enclosure
Rack rail
When installing or removing the drive enclosure to or from the rack, make
•
sure that the sides and the bottom of the drive enclosure are held by two or
more people. Failure to do so may cause injury.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
M5 screw
Washer
(Rear view of rack pillar)
Rack rail (right)
[Right]
Sixth screw
(M5 screw)
First screw
(M5 screw)
[Right]
Fifth screw
(M5 screw)
Second screw
(M5 screw)
56
M5 screw
Washer
Step (1).
P3AG-1842-06ENZ0