Fujitsu ETERNUS AF250 S2 Basic Operation Manual page 55

5. Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
A screen that shows which DE-ID the additional drive enclosure is to be connected to, the type of
drive enclosure that is to be added, and the procedure to add the drive enclosure is displayed.
3
Wear a wrist strap or touch a metal part to discharge the human body's natural static electricity.
4
Install the drive enclosure in the rack.
This step explains how to install drive enclosures that are used in regions other than the EMEIA, Central
American, and Caribbean regions.
(1)
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the front
and rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rails must be attached to
the rack before they can be completely tightened.
[Left]
(Front view of rack pillar)
(2)
Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the washers to fasten the rack
rails to the rear rack pillars.
Loosen the M4 screws to
adjust the length of the rack
rails to match the distance
between the front and
rear rack pillars.
Rack rail (left)
"L" indicated inside
[Right]
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
(Rear view of rack pillar)
Rack rail (right)
"R" indicated inside
55
P3AG-1842-06ENZ0