Fujitsu ETERNUS AF250 S2 Basic Operation Manual page 69

5. Component Expansion/Function Enhancement
Adding Servers
■
Host Group Addition
Add the information on the hosts (servers) that access the ETERNUS AF via the host interface port.
A host group is a group of HBAs that have the same host interface and access the same LUN groups.
Make sure to perform the appropriate host response settings before performing host group registration.
If the appropriate host response settings are not set, the volumes may not be recognized or the expected
performance may not be achieved.
The procedure to register a host group is as follows:
1
Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen.
2
In [Action], click the [Add Host Group] that corresponds to the host interface of the server that is to be
added.
The screen to add a host group appears.
3
Specify a host group name to be created, and select a host response to be assigned to the host group.
4
Register a host in a host group, and then click the [Add] button.
A confirmation screen appears.
5
Click the [OK] button.
The host group is added and the registration completion screen appears.
■
CA Port Parameter Settings
Set the CA port parameters if the port information of the ETERNUS AF needs to be changed because of the server
that is to be added.
When any server is already connected, make sure that the server will not be affected by the change.
For details on how to change the settings, refer to "Configuration Guide (Web GUI)".
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
69
P3AG-1842-06ENZ0