Fujitsu ETERNUS AF250 S2 Basic Operation Manual page 38

Hide thumbs Also See for ETERNUS AF250 S2:
Table of Contents

Advertisement

2.
Basic Operation
Powering On and Off
When the ETERNUS AF is turned off, the power shuts off after the write data in the cache memory is written
back to the drives. As a result, it may take approximately eight minutes or up to 10 minutes maximum for
the power supply to be completely turned off.
Do not turn off the power of the ETERNUS AF and the network devices that connect the ETERNUS AF to a
server while the server is operating. This may result in the loss of data or prevent data from being saved in
the ETERNUS AF.
When using a power synchronized unit for power control, turn off the power of the ETERNUS AF via the pow-
er synchronized unit. When a power synchronized unit is connected, the power of the ETERNUS AF is auto-
matically turned on because the power synchronization function is activated.
To turn off the ETERNUS AF250 S2, use the Power switch, a power synchronized unit, ETERNUS Web GUI, or
ETERNUS CLI. If any other method is used to turn off the ETERNUS AF, the replacement cycle for the battery
is shortened significantly because the battery continues to charge and discharge.
After power-off, wait for about one minute before turning power on again.
This section explains how to use the Power switch to turn off the ETERNUS AF.
For other procedures, refer to the related manuals.
1
Press and hold the Power switch of the controller enclosure for four seconds or more.
Power switch
The READY LED on the controller enclosure is turned off.
Press the Power switch only once. If the Power switch is pressed again between the time of the READY
LED turning off and the POWER LED turning off, the ETERNUS AF power may turn on.
2
The power of the ETERNUS AF is disconnected.
When the power is disconnected, the POWER LED of the controller enclosure and the POWER LEDs of the
drive enclosures are turned off.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
Controller enclosure
38
P3AG-1842-06ENZ0

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eternus af250

Table of Contents