Ramhino Diagnostic Tool - JLG X390AJ-X14J Supplement Manual

SECTION 3 - TROUBLESHOOTING AND FAULT CODES
3.3

RAMHINO DIAGNOSTIC TOOL

RamHino is an application which allows communication
with the CAN BUS circuit of the machine. A Peak CAN
device is used for connection between the PC/laptop and
the machine CAN BUS circuit.
The tool is useful for service on lithium machines, as it
shows detailed overview of the battery pack status and
how the pack components are working. On the lithium
machine, the settings and the information for the diag-
nostics about the components of the battery pack group
can be found by RamHino only.
Only for 48V Lithium Battery Pack, when the battery char-
ger is connected and the BMS is ON, the RamHino Lithium
page can be seen even if the machine is OFF.
For X23J machine, the battery Pack has a specific CAN BUS
cable for the Lithium main components (BMS, Inverter,
Battery Charger); this CAN BUS Line is connected to the
platform CAN BUS Line by a CAN Bridge Box. CAN Bridge
Box is switched On by the main board (ECM1- 2), so Ram-
Hino connection by the emergency remote control plug
can be used only when the machine is ON.
For instruction on the installation of the Peak CAN device
and the use of the RamHino application refer "RamHino
Tool Instructions for use".
RamHino data: For all Battery Pack versions (1St, 2nd and 3rd
Generation)
Remote control Screen on Input menu: Only for 3rd Generation
3-30
MAF17030
MAF17040
31215460