Data Report - netvox R718CT2 User Manual

5. Data Report

The device will immediately send a version package report and a report data with temperature and humidity and voltage values.
The device sends data in the default configuration before any configuration is done.
Maximum time: Max Interval (default 900 seconds)
Minimum time: Min Interval (default 900 seconds) (by default, the current voltage value is detected per Min Interval)
Default reportchange:
Battery --- 0x01 (0.1V)
TempChange----0x01 (1°C);
Note: The real data sending cycle will be programmed before shipment.
The interval between two reports must be the minimum time
Data report configuration and sending period are as following:
Min Interval
(Unit:second)
Any number between 1~65535
Example#1
based on MinTime = 1 Hour, MaxTime= 1 Hour, Reportable Change i.e. BatteryVoltageChange=0.1V
MaxTime
S
leeping(MinTime)
Wakes up and collects data
REPORTS 3.6V
Note: MaxTime=MinTime. Data will only be report according to MaxTime (MinTime) duration regardless BtteryVoltageChange value.
Example#2
based on MinTime = 15 Minutes, MaxTime= 1 Hour, Reportable Change i.e. BatteryVoltageChange= 0.1V.
S
leeping(MinTime)
0H 15 th M
Wakes up and Wakes up and
collects data
collects data
REPORT 3.6V 3.6V
Does not report
Max Interval
Reportable Change
(Unit:second)
Any number between
Can not be 0.
1~65535
Wakes up and collects data
REPORTS 3.5V
MaxTime
sleeping sleeping
30 th M 45
Wakes up and
Wakes
collects data
collects data
3.6V
3.6V
Does not report
Does not report
Current
Reportable Change
Report
per Min Interval
MaxTime
S
leeping(MinTime)
sleeping
th M 1H
up and Wakes up and
collects data
REPORTS
3.6V
4
Change≥ Current Change
Reportable Change
Report
per Max Interval
Wake up and collects data
REPORTS 3.6V
＜
2H