Table of Content 1. Introduction................................2 2. Appearance................................. 3 3. Main Features................................3 4.Set up Instruction.................................4 4.1 Power on and Turn on / off..........................4 4.2 Join Into LoRa Network...........................4 4.3 Function Key..............................4 4.4 Data Report...............................5 5. Restore to Factory Setting............................6 6.
Introduction R718H2 is the wireless 2-Input Pulse Counter Interface of Netvox ClassA type device based on LoRaWAN open protocol, compatible with LoRaWAN protocol. LoRa Wireless Technology: LoRa is a wireless communication technology dedicated to long distance and low power consumption. Compared with other communication methods, LoRa spread spectrum modulation method greatly increases to expand the communication distance.
2. Appearance Fig.1 R718H2 Appearance 3. Main Features Compatible with LoRaWAN Detect pulse status Simple operation and setting External pulse input level is not higher than 3.0V 2 ER14505 lithium batteries (3.6V / section) parallel power supply...
The green indicator will stay on for 5 seconds to show it joins into the network, otherwise, the green indicator will be off. (2) If R718H2 had been joined into a LoRa network, remove and insert the batteries; it will repeat step (1).
4.4 Data Report When the device is powered on, it will immediately send a version package report and a report data including the current pulse count and voltage value. The device sends data in the default configuration before any configuration is done. The pulse count is sent according to the maximum and minimum interval, and the count is automatically cleared after transmission;...
1. Press and hold function key for 5 seconds till the green indicator flashes and then release; LED flashes quickly 20 times. 2. R718H2 is at off mode by default setting after restoring to factory setting. Note: The device operation of turning off is the same as the device restore factory settings.
(B) When it is not in the network → R718H2 will enter sleeping mode and wake up every 15 seconds to search a network to join in the first two minutes. After two minutes, it will wake up every 15 minutes to request to join the network.
Page 9
circuit boards and delicate structures. • Do not wash with strong chemicals, detergents or strong detergents. • Do not apply with paint. Smudges can block debris in detachable parts and affect normal operation. • Do not throw the battery into a fire to prevent the battery from exploding. Damaged batteries may also explode.