netvox R718IB2 User Manual

netvox R718IB2 User Manual

Wireless 2-input 0-10v adc sampling interface
Hide thumbs Also See for R718IB2:

Advertisement

Quick Links

R718IB2
Model:
Wireless 2-Input 0-10V ADC Sampling Interface
Wireless 2-Input 0-10V ADC Sampling Interface
R718IB2
User Manual

Advertisement

Table of Contents
loading

Summary of Contents for netvox R718IB2

  • Page 1 R718IB2 Model: Wireless 2-Input 0-10V ADC Sampling Interface Wireless 2-Input 0-10V ADC Sampling Interface R718IB2 User Manual...
  • Page 2: Table Of Contents

    Table of Content 1. Introduction................................2 2. Appearance................................. 3 3. Main Features................................3 4.Set up Instruction.................................4 4.1 Power on and Turn on / off..........................4 4.2 Join Into LoRa Network...........................4 4.3 Function Key..............................4 4.4 Data Report...............................5 5. Restore to Factory Setting............................5 6.
  • Page 3: Introduction

    Introduction The R718IB2 is a Class A type devices based on the LoRaWAN open protocol and is compatible with the LoRaWAN protocol. 1. To check the device voltage according to the configuration time interval. 2. To press the function key to detect the current voltage.
  • Page 4: Appearance

    2. Appearance Fig.1 R718IB2 Appearance 3. Main Features  Compatible with LoRaWAN protocol.  Powered by 2 x ER14505 3.6V Lithium AA battery  Capable to detect voltage input 0-10V  Easy set up and installation...
  • Page 5: Set Up Instruction

    The green indicator will stay on for 5 seconds to show it joins into the network, otherwise, the green indicator does not work. (2) If R718IB2 had been joined into a LoRa network, remove and insert the batteries; it will repeat step (1).
  • Page 6: Data Report

    1. Press and hold function key for 5 seconds till the green indicator flashes and then release; LED flashes quickly 20 times. 2. R718IB2 is at off mode by default setting after restoring to factory setting. Note: The device operation of turning off is the same as the “Restore Factory Settings” operation.
  • Page 7: Sleeping Mode

    (B) When it is not in the network → R718IB2 will enter sleeping mode and wake up every 15 seconds to search a network to join in the first two minutes. After two minutes, it will wake up every 15 minutes to request to join the network.
  • Page 8 also explode. All of the above suggestions apply equally to your device, battery and accessories. If any device is not working properly. Please take it to the nearest authorized service facility for repair.

Table of Contents