Wireless 2-input ma current meter interface (8 pages)
Summary of Contents for netvox R718IA2
Page 1
This document contains proprietary technical information which is the property of NETVOX Technology. It shall be maintained in strict confidence and shall not be disclosed to other parties, in whole or in part, without written permission of NETVOX Technology. The...
Table of Content 1. Introduction ..................................2 2. Appearance ..................................2 3. Main Feature ..................................3 4. Set Up Instruction ................................4 5. Data Report ..................................5 6. Installation ..................................8 7. Information about Battery Passivation ..........................9 7.1 To determine whether a battery requires activation ....................9 7.2 How to activate the battery ............................
1. Introduction R718IA2 is a voltage detection device that is a Class A device based on the LoRaWAN open protocol and is compatible with the LoRaWAN protocol. R718IA2 will check the voltage of device regularly according to the configured time, and the ADC sampling voltage range is 0-5V.
Low power consumption and long battery life Battery Life: ⁻ Please refer to web: http://www.netvox.com.tw/electric/electric_calc.html ⁻ At this website, users can find battery life time for variety models at different configurations. 1. Actual range may vary depending on environment.
4.Set Up Instruction On/Off Power on Insert batteries (user may need a screwdriver to open) Turn on Press and hold the function key for 3 seconds till the green indicator flashes once Turn off (Restore to factory setting) Press and hold the function key for 5 seconds till green indicator flashes 20 times Power off Remove Batteries 1.
1. The cycle of the device sending the data report is according to the default. 2. The interval between two reports must be the MinTime. Please refer Netvox LoRaWAN Application Command document and Netvox Lora Command Resolver http://www.netvox.com.cn:8888/page/index to resolve uplink data.
Page 8
Example#2 based on MinTime = 15 Minutes, MaxTime= 1 Hour, Reportable Change i.e. BatteryVoltageChange= 0.1V. MaxTime Sleeping(MinTime) sleeping sleeping sleeping Wakes up and Wakes up and Wakes up and Wakes up and Wakes up and collects data collects data collects data collects data collects data REPORT 3.6V...
6. Installation 1. Wireless ADC Sampling Interface (R718IA2) has the built-in 2. Connect the sampling line of the ADC sampling interface magnet (as the figure below). When installed, it can be attached to sensor to the transmitter according to the wiring method the surface of an object with iron which is convenient and quick.
(if using an electric screwdriver, it is recommended to set the torque as 4kgf) to ensure the device is impermeable. 7. Information about Battery Passivation Many of Netvox devices are powered by 3.6V ER14505 Li-SOCl2 (lithium-thionyl chloride) batteries that offer many advantages including low self-discharge rate and high energy density.
8. Important Maintenance Instruction Kindly pay attention to the following in order to achieve the best maintenance of the product: • Keep the equipment dry. Rain, moisture and various liquids or water may contain minerals that can corrode electronic circuits. In case the device is wet, please dry it completely. •...