Table of Contents
Advertisement
5. Data Report
When the device is turned on, it will immediately send a version package.
Data will be reported once per hour by default setting.
Default Setting:
Maximum Time: 0x0E10 (3600s)
Minimum Time: 0x0E10 (3600s)
Battery Change: 0x01 (0.1V)
LastMessageResendTime: 0x00
Dry Contact Detection Trigger:
When the dry contact is connected, the data status bit is "1".
When the dry contact is disconnected, the data status bit is "0".
Last Message Resend Time Function:
Resendtime = 0x00 or 0xFF, send the current dry contact state
Resendtime = 0x03 to 0xFE, send the current dry contact state, and resend the dry contact state after 3-254s
*The function of Resendtime is supported by the firmware version after 2020/05/08 version
Note:
The device send data cycle depends on real burning configuration.
The interval between two reports must be the minimum interval.
Data report configuration and sending period are as following:
Min. Interval
(Unit:second)
Any number between
1~65535
5.1 Example of ReportDataCmd
FPort：0x06
Bytes
1
Version
Version– 1 byte –0x01——the Version of NetvoxLoRaWAN Application Command Version
DeviceType– 1 byte – Device Type of Device
The devicetype is listed in Netvox LoRaWAN Application Devicetype doc
ReportType – 1 byte –the presentation of the NetvoxPayLoadData，according the devicetype
NetvoxPayLoadData– Fixed bytes (Fixed =8bytes)
// Detect the current voltage value every 3600s by default setting
Max. Interval
(Unit:second)
Any number between
1~65535
1
1
DeviceType
ReportType
Reportable Change
Reportable Change
Can not be 0.
5
Current Change≥
Report
per Min. Interval
Var(Fix=8 Bytes)
NetvoxPayLoadData
Current Change＜
Reportable Change
Report
per Max. Interval
Advertisement
Table of Contents
