Table of Contents
Advertisement
4.2 Join into the Network
To join the device into LoRa network to communicate with LoRa gateway.
The network operation is as following:
(1) If the device had never joined any network, turn on the device; it will search an available LoRa network to join. The green
indicator will stay on for 5 seconds to show it joins into the network, otherwise, the green indicator will be off.
(2) If the device had been joined into a LoRa network, remove and insert the batteries; it will repeat step (1).
4.3 Function of Keys
(1) Press and hold function key for 5 seconds to reset to factory setting. After restoring to
factory setting successfully, the green indicator will flash quickly 20 times.
(2) Press function key to turn on the device which is in the network and the green indicator will flash once and the device will
send a data report.
4.4 Data Report
When the device is turned on, it will immediately send a version package.
Data will be reported once per hour by default setting.
Maximum time: 3600s
Minimum time: 3600s (Detect the current voltage value every 3600s by default setting)
Default reportchange:
Battery ---- 0x01 (0.1V)
Dry contact detection trigger:
When the dry contact is connected, the data status bit is "1".
When the dry contact is disconnected, the data status bit is "0".
Note:
The device send data cycle depends on real burning configuration.
The interval between two reports must be the minimum interval.
4
Advertisement
Table of Contents
