Figure 14. Holding The Rj-45 Cable Connectors; Table 11. Rj-45 To Db-9 Pinouts - iDirect evolution x5 Installation Manual

Holding the RJ-45 cable connectors side by side with the tab at the back, as shown below,
examine the sequence of the colored wires to determine the type of RJ-45 cable as shown in
Figure 14.
• Straight through — The colored wires are in the same sequence at both ends of the cable.
• Crossover — The first (far left) colored wire at one end of the cable is the third colored
wire at the other end of the cable.
Table 11 lists the signal and pinouts for the asynchronous serial Console Port and the RJ-45 to
DB-9 female DTE adapter. A picture of the adapter is shown

Table 11. RJ-45 to DB-9 Pinouts

Console Port
(DTE)
RTS
DTR
TxD
GND
GND
RxD
DSR
Rx-RF-Power
iDirect Evolution X5 Satellite Router Installation and Safety Manual

Figure 14. Holding the RJ-45 Cable Connectors

RJ-45 Pin Color Code
1
2 Orange
3
4
5 Green
6 Yellow
7 Brown
8 White/Grey
Figure 15 on page
RJ-45 to DB-9
Terminal Adapter
Blue
Black
Red
Preparing the Coax Cables
30.
Console
Device
8 CTS
6 DSR
2 RxD
NC GND
5 GND
3 TxD
4 DTR
9 --
29