Advertisement
How To's
Engage™ and Inspire™ Consoles
REPLACEMENT OF OvERLAy AND BEZEL ASSEMBLy
1. remove the LCD console from the base unit by removing and
saving the four screws that secure the console to the console
support bracket.
2. Disconnect the cabling from the base unit to the console.
3. remove and save the six Phillips screws that secure the rear
console case to the overlay/bezel assembly.
4. remove and save the four Phillips screws (shown in the illustration)
that secure the PCB Mounting bracket assembly to the overlay/
bezel assembly.
5. Tread only: disconnect green wire from the rear plastic to ESD PCB.
6. Inspire
Consoles only: disconnect the keypad's tails from MIB.
TM
7. Cut cable tie that secures the internal iPod
8. Disconnect the USB, headphones, and iPod
panel assembly.
9. Install the new overlay/bezel assembly in reverse order using the
hardware removed and saved in previous steps.
REPLACEMENT OF 7-SEGMENT DATA DISPLAy BOARD (I-CONSOLES)
1. Remove the rear console case.
2. remove the overlay/bezel assembly.
3. remove and save the four Phillips screws (shown in the illustration)
that secure the data display PCB to the PC mounting bracket.
4. Disconnect any cables as required.
5. re-use the spacers from the old Data Display PCB on the
new Data Display PCB
6. Install the new Data Display PCB in reverse order using the
hardware removed and saved in the previous steps.
Data Display
Mounting Screws
cable to the plastic.
®
cables from the option
®
(4)
PCB Bracket
Mounting Screws
Data Display Board
CN 36
M051-00K70-B111
PCB Mounting
Bracket Assembly
37
Hide quick links:
Advertisement
