Advertisement
Error Message Tables
Engage™ and Inspire™ Consoles
MESSAGE
"Notify maintenance
motor controller
error (low voltage
detected).
"Start up error."
"Motor disabled."
"Incline inoperative -
continue if desired."
DESCRIPTION
Non-fatal error.
Line voltage dropped
to an insufficient level
to sustain proper
operation.
Non-fatal error.
No/low motor current
is detected at start-
up.
Non-fatal error.
The M/C has
detected an open
stop switch when
operating that the
console has not
detected.
Indicates the
incline system
has a problem but
system can still be
used. Occurs if
DSP reports a lift
Home Switch error or
timeout error.
POSSIBLE CAUSE
Line cord is not
securely plugged into
the wall or machine.
Loose/intermittent
receptacle wiring.
Machine is not
plugged into a proper
dedicated line.
Incoming voltage is
fluctuating, dipping to
an insufficient level.
Motor unplugged or
connector loose.
A possible but
unlikely cause would
be the user driving
the belt at startup.
An intermittent
console/motor
controller cable or
emergency stop
switch.
Improper home
or decline switch
operation /
adjustment /
cable. Incline
motor connection
unplugged / loose.
A possible but
unlikely cause would
be incline motor
overheating from
excessive operation.
REMEDy
Confirm that the cord is solidly plugged into
the wall receptacle and the machine.
Contact an electrician to diagnose/correct a
power line problem.
Verify that the motor connections are solid.
Perform a phase test to verify the system or
diagnose a phase problem.
Confirm that all connections are solid, all
wires are properly seated into the connector
and the cable is not pinched and being
shorted/open. Verify proper operation of the
emergency stop switch.
Verify that all motor and switch connections
and cables are solid.
Verify incline switch operation using
diagnostic switch LEDS (LED 9&10). Verify
incline motor activation using diagnostic
LEDS (LED 4&5).
readjust or replace switches/cables.
CN 16
M051-00K70-B111
19
Hide quick links:
Advertisement
