LifeFitness ELEVATION Series Service Manual page 21

Error Message Tables
Engage™ and Inspire™ Consoles
MESSAGE
"Stop key activated."
"Unable to attain
target speed."
1
"Miscellaneous
interface
communication
error."
"Workout initialization
time-out.
resetting system....."
"Please replace
emergency stop
switch."
When user sees this message the belt speed will decrease automatically. If user is already at minimum speed (i.e.
1
0.5 mph) then workout will enter Pause mode. If speed is more than one mph/kph below target speed then speed is
reduced by ½. If speed is closer to target when an "Unattained..." occurs then speed is decremented between 0.1 to
0.3 mph/kph.
A simple test to determine if console is communicating with the motor controller is to cycle power and listen for
2
beeps from the MIB board. The MIB will beep once after it gets power followed by three additional beeps if it can
successfully communicate with the motor controller. This process is done before the main Application on the SBC is
up and running (i.e. before you see the "Splash" screen which contains the word "initializing" on it).
DESCRIPTION
MIB has decoded
a Stop key press.
System aborts
workout.
Reported if the motor
controller was unable
to attain the desired
user's speed after a
given amount of time.
Typically this is
reported if SBC was
unable to properly
activate the belt and/
or incline motors.
System was unable
to enable the belt
and/or incline motors
while starting a
workout.
Emergency stop
(tether) is replaced,
but console still gives
this message.
POSSIBLE CAUSE
Faulty Activity Zone
keypad.
Line voltage low, unit
overloaded; too much
weight for speed
requested.
Worn belt and/or
deck.
Communications
error with the motor
controller.
Communications
error with the motor
controller.
Tether / magnet loose
or not installed;
Poly-resettable fuse
(PTC2) or Q5 on MIB
are open;
Over-current
condition on
emergency stop relay
on motor controller.
REMEDy
Check proper operation of keypad in
diagnostics and replace if necessary.
Check belt & deck for signs of excessive wear
and replace if necessary.
See "Module communication error."
See "Module communication error."
Verify tether / magnet are properly replaced /
installed.
Replace MIB.
Replace motor controller.
CN 18
M051-00K70-B111
21