Sending Solaris Disk Information To The Storage System - Dell EMC2 AX100 Series Installing Manual

Sending Solaris Disk Information to the Storage System

Start the Server Utility
Register the Server with the Storage System
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a Solaris Server
Read this section for all configurations.
You must rerun the Navisphere Server Utility to send to the storage
system the Solaris device name and volume or file system
information for each virtual disk that the server sees. Navisphere
Express displays this information on its Details page for each virtual
disk.
On the Solaris server, enter
/opt/Navisphere/bin/axnaviserverutil
If the server utility does not start, the storage system may still be rebooting.
When the reboot is complete, the SP Boot/Fault light on the back of each SP is
off and not blinking.
The utility automatically scans for connected AX100-Series storage
systems, and displays a list of the ones it finds.
In the Server Utility, enter u to register the server with each storage
system the utility found.
The utility sends to each storage system the server's name and IP
address and the Solaris device name and volume or file system
information for each virtual disk in the storage system that the server
sees.
Sending Solaris Disk Information to the Storage System
67