Dell EMC2 AX100 Series Installing Manual page 14

Installing PowerPath on the Server
Verify the PowerPath Installation
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a Solaris Server
14
13. If you are installing PowerPath for the first time, or if you are
upgrading from PowerPath 4.0.1 or earlier, reboot the server with
reboot -- -r.
If you are upgrading from PowerPath 4.0.2 or later, you need not reboot
the host after you install PowerPath 4.3. However, you must shut down
all applications before you install PowerPath 4.3. Therefore, if the host
boots off a PowerPath pseudo device, you must reboot after the upgrade.
If the sd or ssd driver does not exist on the server, you see one of
the following messages during boot:
WARNING: forceload of drv/sd failed
or
WARNING: forceload of drv/ssd failed
You can safely ignore this warning.
1. Verify that PowerPath is installed properly on the server:
pkginfo -l EMCpower
You should see output similar to this:
PKGINST: EMCpower
NAME: EMC PowerPath
CATEGORY: system
ARCH: sparc
VERSION: 4.3.0_bxxx
BASEDIR: /opt
VENDOR: EMC
PSTAMP: cambridge951018123443
INSTDATE: Mar 14 2003 08:36
STATUS: completely installed
FILES: 292 installed pathnames
5 shared pathnames
17 directories
139 executables
137622 blocks used (approx)
2. Verify that the PowerPath kernel extensions are loaded on the
host:
modinfo | grep emcp.