Installing The Storage System - Dell EMC2 AX100 Series Installing Manual

Installing the Storage System

Before You Start
Install the Storage System in a Cabinet
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a Solaris Server
Read this section if you are installing a new storage system.
You install the storage system in a 19-inch NEMA-standard
cabinet/rack.
To complete this procedure, you need the mounting hardware that
shipped with the storage system.
1. Refer to Figure 3 as you install each rail in the cabinet:
a. From the front of the cabinet, insert the alignment pins in the
rear channel of the cabinet. Note that the pins insert in the
1/2-inch space between channel holes (marked by a — slash
mark in some cabinets).
b. Pull the adjustable rail forward, and attach it with two screws
to the inside of the front channel in the two center holes.
c. From the rear of the cabinet, secure each rail to the rear
channel. Leave the screws slightly loose to allow for
adjustment after the storage system is loaded on the rails.
Installing the Storage System
21