Dell EMC2 AX100 Series Installing Manual page 15

Verify That PowerPath Commands Are in Your Path
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a Solaris Server
You should see output similar to this:
37 13254e0 2a09 256
45 1361a89 7b7ea 254
46 138b0df 18597
47 13a1a96 30ac5
48 13cff63 1c81e
49 781dc000 1cded
50 781fa000 dacfa
51 13ea5c1 123f5
52 13fbf1e 2648
53 782d6000 46c22
56 783da000 5cb69
57 7843a000 52921
58 7848e000 250c8
59 781f5a95 273
Check that the PowerPath commands are in your path. PowerPath
installation modifies the /etc/profile and /etc/.login files to run the
PowerPath setup scripts, which modify the PATH,
LD_LIBRARY_PATH, LD_LIBRARY_PATH_64, and MANPATH
variables on the server. These changes take place after you reboot the
host; if reboot was not required, you must log out and then log back
in to force these changes.
If you find that the PowerPath commands are not in your path, check
the /.profile, /.login, and /.cshrc scripts to see if they are overwriting
the changes made by the PowerPath setup scripts.
The installation changes your path to point to the appropriate CLIs (32 bit or
64 bit). We recommend that you accept the path the installation adds;
changing the path is not supported.
Installing PowerPath on the Server
1 emcpsf (PP SF 4.3.0)
1 emcp (PP Driver 4.3.0)
- 1 emcpmp (PP MP Ext 4.3.0)
- 1 emcpmpc (PP MPC Ext 4.3.0)
- 1 emcpmpaa (PP MPAA Ext 4.3.0)
- 1 emcpmpap (PP MPAP Ext 4.3.0)
- 1 emcpsapi (PP SAPI Ext 4.3.0)
- 1 emcpcg (PP CG Ext 4.3.0)
- 1 emcphr (PP HR Ext 4.3.0)
- 1 emcpsm (PV SM Ext 4.3.0)
- 1 emcpsc (PV SC Ext 4.3.0)
- 1 emcpevm (PV EVM Ext 4.3.0)
- 1 emcpdpm (PV DPM Ext 4.3.0)
- 1 emcpioc (PP PIOC 4.3.0)
15