Dell EMC2 AX100 Series Installing Manual page 56

Registering the Server with the Storage System
Set the Utility to Restart on Reboot
Start Navisphere Express
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a Solaris Server
56
Set the utility to restart automatically each time the server reboots by
using a text editor to modify login scripts as follows:
1. If you are running Common Desktop Environment, remove the
comment from the last line in $HOME/.dtprofile.
The line should read:
DTSOURCEPROFILE=true
2. Make the following addition to PATH in $HOME/.profile or
$HOME/.cshrc, and export the path:
/opt/Navisphere/bin
1. Open an Internet browser, such as Internet Explorer or Netscape,
on the server or on any host on the same LAN as the storage
system.
2. Enter the IP address of an SP in the storage system.
The IP address is one you assigned when you initialized the storage
system (from the Storage-Management Ports section of the planning
.
guide)
If Navisphere Express does not open, make sure that the storage
system is not rebooting. When the reboot is complete, the
SP Boot/Fault light on the back of each SP is off and not blinking.
If the storage system is not rebooting and Navisphere Express still
does not open, go to the "Troubleshoot" section on the AX100
support website or the AX100-Series Documentation CD.
3. Log in to Navisphere Express by entering the username and
password.
The username and password are the ones that you specified when you
initialized the storage system (from the Storage-Management Ports section
of the planning guide).