Dell EMC2 AX100 Series Installing Manual page 64

Configuring an Existing Storage System
What Next?
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a Solaris Server
64
5. Verify that the virtual disks were assigned to the server by
looking at the Manage Servers page.
To display the Manage Servers page - In the Navisphere Express
navigation pane, under Manage, click Servers.
You should see the virtual disks you assigned to the server listed
in the Virtual Disks column of the server's row.
If you do not see virtual disks, go to the "Troubleshoot" section on
the AX100 support website or the AX100-Series Documentation
CD.
6. On the Solaris server, scan for the virtual disks:
devfsadm -C
7. Use the format command to verify that Solaris recognizes the
virtual disks (LUNs).
If Solaris does not recognizes the virtual disks, reboot the server:
reboot - - -r
8. Configure PowerPath:
/etc/opt/emcpower/powercf -q
powermt config
9. On the server, verify that PowerPath sees all the paths to the
virtual disks with the PowerPath command:
powermt display dev=all
Go to Preparing Virtual Disks to Receive Data (page 65).