Dell EMC2 AX100 Series Installing Manual page 48

Initializing the Storage System
Change the Management Network Parameters and User Account Settings
To Shut Down the Storage System
To Start Navisphere Express
To Shut Down the Storage System with Navisphere Express
To Shut Down the Storage System with the Power Switch
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a Solaris Server
48
If you need to change the management network parameters or user
account settings after you initialized the storage systems, you must
Shut down the storage system.
Reset the storage system.
Rerun the initialization utility to set the parameters.
You can shut down the storage system with Navisphere Express or
the power switch.
1. Open an Internet browser, such as Internet Explorer or Netscape,
on the server or on any host on the same LAN as the storage
system.
2. Enter the IP address of an SP in the storage system.
This address is the one you assigned when you initialized the storage
system.
If Navisphere Express does not open, make sure that the storage
system is not rebooting. When the reboot is complete, the
SP Boot/Fault light on the back of each SP is off and not blinking.
If the storage system is not rebooting and Navisphere Express still
does not open, go to the "Troubleshoot" section on the AX100
support website or the AX100-Series Documentation CD.
3. Log in to Navisphere Express by entering the username and
password that you specified when you initialized the storage
system.
1. In the Navisphere Express navigation pane under System, click
Service.
2. In the System Shutdown page, click Shutdown.
Press the power button down for about a second.