Configuring Additional System Parameters - Dell EMC Data Domain DD9800 Installation Manual

8. Enter up to three DNS servers to use for resolving host names to IP addresses. Use a comma-separated or space-separated
list. Enter a space for no DNS servers. Or accept the IP addresses of the DNS servers, if the system was able to discover
them.
DNS Servers
Enter the DNS Server list (zero, one, two or three IP addresses):
192.168.10.1
9. A summary of the network settings is displayed. You can accept the settings (Save), reject the settings and exit to the CLI
(Cancel), or return to the beginning of the current section and change the settings (Retry). Entering Retry displays your
previous responses for each prompt. Press Return to accept the displayed value or enter a new one.
Pending Network Settings
Hostname
Domain name
Default Gateway
DNS Server List
Port Enabled
----- -------
eth0a no
eth0b no
eth0c no
eth0d no
ethMa yes
ethMb no
ethMc no
ethMd no
ethMe no
ethMf no
----- -------
Do you want to save these settings (Save|Cancel|Retry):

Configuring additional system parameters

About this task
Most installations would benefit from the configuration of a few additional system parameters, provided in this section for
convenience.
NOTE: You can also use the Data Domain (DD) System Manager GUI interface to configure the system parameters. Open
a web browser, and enter your Data Domain system's IP address in the browser's address text box. Log in when the DD
System Manager login screen displays. Use the DD System Manager online help for more information.
Steps
1. To set up the mail server, enter:
# config set mailserver mail.datadomain.com
The Mail (SMTP) server is: mail.datadomain.com
2. To set up the system location, enter:
# config set location "Dallas Regional Data Center Lab,
5000 Apple Drive Suite #130, Dallas, Tx"
The System Location is: Dallas Regional Data Center Lab,
5000 Apple Drive Suite #130, Dallas, Tx
3. To add one or more time servers, enter:
NOTE: HA configuration requires that the two nodes maintain a time difference of no more than 10 seconds.
# ntp add timeserver 192.168.101.1
Remote Time Servers: 192.168.10.1
4. To enable the NTP daemon, enter:
# ntp enable
NTP enabled.
5. To change the system time zone, enter:
84 Configure System for Use
ddbeta1.dallasrdc.com
dallasrdc.com
192.168.10.1
192.168.10.1
Cable DHCP
----- ----
no n/a
no n/a
no n/a
no n/a
yes no
no n/a
no n/a
no n/a
no n/a
no n/a
----- ----
IP Address
--------------
n/a
n/a
n/a
n/a
192.168.10.181
n/a
n/a
n/a
n/a
n/a
--------------
Netmask or Prefix Length
------------------------
n/a
n/a
n/a
n/a
255.255.255.0
n/a
n/a
n/a
n/a
n/a
------------------------