Santak C1K Manual page 3

Safety notes
Operating safety
1. Read safety notes carefully and thoroughly before operation ensure correctly use and save
this manual properly.
2. Pay attention to alarm table on the UPS and operating according to it.
3. Avoid installing the UPS in location under direct sunlight, running water, or excessive humidity.
4. Do not install the device in the environment where close to heating facilities such as space
heaters or furnaces.
5. Place the UPS in a room with good ventilation and safe distance. Refer to manual to perform
installation.
6. Cleaning with dry stuff, do not use liquid or spray detergent.
7. In the event of fire alarm occurring in the vicinity, please use dry power fire extinguishers.
The use of liquid fire extinguishing agents may causes electric shock.
Electric safety
1. Verify that cabling and battery cable polarity are correct and earth connection well before
switching on the UPS.
2. Before moving or re-wiring the UPS, please disconnect the mains source and make sure the
UPS is completely shut down. Or else, the output terminal may carry live voltage, thus present-
ing electric shock risk.
3. Please use fitting and accessories were appointed by SANTAK.
4. To meet the requirement of EMC, the length of the output should be less than 10m.
Battery safety
1. High ambient temperature shortens the batter's lifetimes, so the battery should be replaced
periodically to ensure normal UPS operation and for adequate autonomy time.
2.Servicing of battery should be performed or supervised by personnel knowledgeable of battery.
3. In replacement of battery, please use the same number and type of battery.
4.A battery can present a risk of electrical shock and high short circuit current. The following
precaution should be observed when working on batteries.