3
Installation
Figure 3-2 Connection method of output for C1K(S)~C3K(S)
Apart from using the socket for output, C3K(S) has the terminal block
available for output as well when the output current over 10A recommended.
The wring configuration is shown in the following diagram.
1)
Remove the cover of the terminal block;
2)
Use AWG14 (2.1mm
3)
Upon completion of the wiring configuration, please check whether
the wires are securely affixed;
4)
Put back the terminal block cover to the rear panel.
8
2
) wires for wiring configuration;