Loading Envelopes - Ricoh AP2600 Operating Instructions Manual

Paper and Other Media
D
Load paper into the paper tray
with the print side down.
3
Important
Confirm that the top of the stack
is not higher than the limit mark
inside the tray.
Confirm that paper fits under
the rear guide.
E
While lifting the front of the tray,
place the tray into the printer.
Then slide it inside until it stops.
Important
Do not slide the paper tray in
with force. If you do, the front
and side guides might move.
44

Loading Envelopes

As there are many kinds of envelopes,
be sure to check if those to be used are
supported by this printer.
Reference
For more information about enve-
lopes, see P.34 "Types of Paper and
Other Media".
Important
Even when the optional Envelope
Feeder Unit is not installed, you
can select the sizes for the enve-
lopes for Tray 2 using the opera-
tion panel. However, you cannot
load the envelopes until the op-
tional Envelope Feeder Unit is in-
stalled.
To install the Envelope Feeder
Unit, the optional Paper Feed Unit
must be installed. See "Installing
Envelope Feeder Type 2600" in the
Setup Guide.
Loading envelopes onto the bypass tray
Reference
With the bypass tray, you can load
up to 10 envelopes at the same
time. For more information about
envelopes, see P.34 "Types of Paper
and Other Media".
A
Open the bypass tray.