Ricoh AP2600 Operating Instructions Manual page 75

Messages/Second messages
I/O Buffer Overflow
Invalid Password
Try Again
Load Correct
Size Paper
/Press #
To Continue
Load Paper
/Paper Size:
Paper Type:
Load Paper
Tray #
Menu Protected
Cannot Change
Error & Status Messages on the Operation Panel
Description
There is too much data for the
I/O buffer to handle.
The password was not en-
tered correctly.
The paper size setting on the
tray differs from that of actual
paper size in the tray.
The paper type and size set-
tings for this tray do not
match the size and type of pa-
per actually loaded.
There is no paper left in this
tray.
The menu is protected and the
settings cannot be changed.
Solution
Make sure the interface cable
is inserted into the printer and
your computer securely.
Make sure the interface cable
is not damaged or broken.
Increase the size of the I/O
buffer.
Wait for two seconds until the
previous display appears.
Then enter the password cor-
rectly.
Load { paper size } paper of
the selected feed direction and
paper size into the tray. Print-
ing will not automatically
resume if the paper size and
direction setting is incorrect.
There are two methods to
resume printing.
A
Use the operation panel to
set the correct paper size
and direction of the paper
in tray.
B Press {Form Feed} and se-
lect the tray with the oper-
ation panel.
Load paper that matches the
paper size and type settings.
Printing will not automatical-
ly resume if the paper type,
size and direction settings are
incorrect. There are two meth-
ods to resume printing.
A
Use the operation panel to
set the correct paper type,
size and direction of the
paper in tray.
B
Press {Form Feed} and se-
lect the tray with the oper-
ation panel.
Load paper into the tray indi-
cated.
Wait for two seconds until the
previous display appears.
5
63