Adjusting The "Registration" Of The Trays - Ricoh AP2600 Operating Instructions Manual

Troubleshooting
C
Press { { { { Enter #} } } } .
Image Density:
-2
D
Press { { { { U U U U } } } } or { { { { T T T T } } } } to set the image
density value.
Note
To maintain a darker image un-
der high volume printing condi-
tions, we highly recommended
that you select 3 from the opera-
tion panel.
You can adjust the image densi-
ty, -3 to +3, from seven steps. In-
creasing the value makes the
5
printouts darker and decreasing
thinner.
E
Press { { { { Enter #} } } } .
F
Press { { { { Online} } } } .
On Line
Job Reset
Form Feed
Power
"Ready" message appears on the
panel display.
Ready
96
Menu
Escape
Enter
Error Data In
Adjusting the "Registration" of
the Trays
You can adjust the registration of
each tray. The vertical adjustment is
used for all trays. Normally, you need
not update the registration. But when
the optional Paper Feed Unit or the
Duplex Unit is installed, updating the
registration is useful in some case.
The following procedure describes
how to adjust Tray 1. You can use the
same procedure to adjust the other
tray as well.
A
Press { { { { Menu} } } } .
Menu
On Line
Job Reset Escape
Form Feed Enter
Power Error
"Menu" appears on the panel display.
B
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display the
"Maintenance" menu, and then
press { { { { Enter #} } } } .
Menu
On Line
Job Reset Escape
Form Feed Enter
Power Error
Maintenance:
Image Density
Data In
Data In