Installation Instructions - Gabarron Elnur INGENIUM Series Installation Instructions & User Manual

IONS

2: INSTALLATION INSTRUCTIONS

odel and it is in good condition.
maintain a
erial as
ated on
Closest
object
to the
left end
Minimum
15cm
Minimum 10cm
Position and fix the brackets at the correct distance from
the floor. It is possible to use the radiator as measuring unit
by positioning it on two polystyrene package elements and
placing two supports above as indicated on the figure:
- The studs and screws to attach the supports are in
the accessories bag.
- Hang the unit on the hooks of the brackets.
- By turning the screws, the metallic square will go
downwards, retaining the heater. Repeat this on
the other bracket.
2
Elnur powered by Gabarrón | INGENIUM WIFI Thermal Radiators | Installation Guide
2. - INSTALLATION INSTRUCTIONS
Shelf
- Open the package and check that it is the correct model and it is in good condition.
- To obtain optimum performances it is necessary to maintain a Minimum 15cm
minimum clearance of
15 cm between the radiator and any inflammable material as
furniture, curtains etc.
- The rest of clearances required to maintain are indicated on Closest
object
the following figure:
to the
right end
Minimum 25cm
Control panel side
Position and fix the brackets at the correct
Mark the fixing points on the
distance from the floor. It is possible to use wall using a pencil through the
two fixing holes in the square
the radiator as measuring unit by positioning
brackets and perform
it on two polyester package elements and
corresponding bores.
placing two supports above as indicated on
the figure:
- The studs and screws to attach the
supports are in the accessories bag.
- Hang the unit on the hooks of the
brackets.
- By turning the screw the metallic
square will go downwards, retaining the
heater. Repeat this on the other bracket.
- Open the package and check that it is the correct
model and it is in good condition.
- To obtain optimum performances it is necessary to
maintain a minimum clearance of 15 cm between
the radiator and any inflammable material as
furniture, curtains etc.
- The rest of clearances required to maintain are
indicated on the figure opposite:
Closest
object
to the
left end
Minimum
15cm
Minimum 10cm
2
Shelf
Minimum 15cm
Minimum 25cm
Control panel side
Mark the fixing points on the
wall using a pencil through the
Mark the fixing points on the
two fixing holes in the square
wall using a pencil through the
brackets and perform
two fixing holes in the square
corresponding bores.
brackets and perform
corresponding bores.
Closest
object
to the
right end
3