Gabarron Elnur INGENIUM Series Installation Instructions & User Manual page 4

3: USING THE THERMAL RADIATOR
3. - USING THE THERMAL RADIATOR
Daily Programming:
Daily Programming
Temperature level for each
Temperature level for each
time interval (1h) of the day.
time interval (1h) of the day.
Temperature setpoint
Temperature setpoint.
Operating mode
Operating mode.
BACKLIGHT
Pressing any button the display will illuminate with a soft white colour. After certain time if no buttons are pressed the display
Backlight backlight will turn off.
Pressing any button the display will illuminate with a soft white colour. After certain time if no buttons are pressed
OPERATING MODES
the display backlight will turn off.
Press , the operation modes are displayed, with the selected one flashing. Use
Operating Modes
mode. Confirm with
The heater has three different operation modes: Auto, Manual override and OFF.
Press , the operation modes are displayed, with the selected one flashing. Use
OK
desired operation mode.
Confirm with .
OK
The heater has three different operation modes: Auto, Manual override and OFF.
Pro
3.1. ON/OFF
AUTO
Once the heater is connected to a main supply you can turn the heater ON by switching the main ON/OFF switch positioned at
the rear right side of the heater as shown above.
Elnur powered by Gabarrón | INGENIUM WIFI Thermal Radiators | Installation Guide
OK / Mode Button
OK / Mode Button
Press the button to select
Press the button to select
operation mode: Auto, Manual,
operation mode: Auto,
Off, and to set the value of the
Manual, Off, and to set
different parameters.
the value of the different
parameters.
.
AUTO MANUAL override
17.5C
ON
Main switch.
Main switch.
All models are
All models are
equipped with one
equipped with one
switch on the back
switch on the back
surface allowing the
surface allowing the
heater disconnection.
heater disconnection.
G-Control Hub
G-Control Hub
connection indicator.
Connection indicator.
Heating on indicator.
Heating on indicator.
Current set point Current set point
temperature in AUTO
temperature in AUTO
mode.
mode.
Config / Prog Button
Press the button to programme
Config / Prog Button
and configure the thermal radiator
Press the button to programme
in AUTO Mode.
and configure the thermal
radiator in AUTO Mode.
or
18.03
OFF
3
to select the desired operation
or to select the
OFF
4