Table of Contents
Advertisement
en the package and check that it is the correct model and it is in good condition.
obtain optimum performances it is necessary to maintain a minimum clearance of 15 cm between the radiator and any
mmable material as furniture, curtains etc.
e rest of clearances required to maintain are indicated on
2. INSTALLATION INSTRUCTIONS
ollowing figure:
- Open the package and check that it is the correct
model and it is in good condition.
- To obtain optimum performances it is necessary to
maintain a minimum clearance of 15 cm between
the radiator and any inflammable material as
furniture, curtains etc.
- The rest of clearances required to maintain are
indicated on the following figure:
tion and fix the brackets at the correct
ance from the floor. It is possible to use
Position and fix the brackets at the correct distance
radiator as measuring unit by positioning
from the floor. It is possible to use the radiator as
measuring unit by positioning it on two polystyrene
n two polyester package elements and
package elements and placing two supports above
ing two supports above as indicated on
as indicated on the figure:
figure:
he studs and screws to attach the
ports are in the accessories bag.
ang the unit on the hooks of the
ckets.
turning the screws, the metallic
are will go downwards, retaining the
ter. Repeat this on the other bracket.
- The studs and screws to attach the supports are in
the accessories bag.
- Hang the unit on the hooks of the brackets.
- By turning the screws, the metallic square will go
downwards, retaining the heater. Repeat this on the
other bracket.
Elnur powered by Gabarrón | RBC | Installation Guide
EN
2.- INSTALLATION INSTRUCTIONS
- Open the package and check that it is the correct model and it is in good condition.
- To obtain optimum performances it is necessary to maintain a minimum clearance of 15 cm between the radiator and any
inflammable material as furniture, curtains etc.
- The rest of clearances required to maintain are indicated on
the following figure:
Minimum
15cm
Position and fix the brackets at the correct
distance from the floor. It is possible to use
the radiator as measuring unit by positioning
it on two polyester package elements and
placing two supports above as indicated on
the figure:
- The studs and screws to attach the
supports are in the accessories bag.
- Hang the unit on the hooks of the
brackets.
- By turning the screws, the metallic
square will go downwards, retaining the
heater. Repeat this on the other bracket.
Closest
object
to the
left end
Closest
object
to the
left end
Minimum
15cm
Minimum 10cm
Minimum 10cm
9
9
Shelf
Minimum 15cm
Shelf
Minimum 15cm
Minimum 25cm
Control panel side
Mark the fixing points on the
wall using a pencil through the
Mark the fixing points on the wall
two fixing holes in the square
brackets and perform
using a pencil through the two
corresponding bores.
fixing holes in the square brackets
and perform corresponding bores.
Closest
object
to the
right end
Closest
object
to the
right end
Minimum 25cm
Control panel side
Mark the fixing points on the
wall using a pencil through the
two fixing holes in the square
brackets and perform
corresponding bores.
3
Advertisement
Table of Contents
