Table of Contents
Advertisement
Available languages
Available languages
EN
2. - INSTALLATION INSTRUCTIONS
- Open the package and check that it is the correct model and it is in good condition.
- To obtain optimum performances it is necessary to maintain a
minimum clearance of
15 cm between the radiator and any inflammable material as furniture,
curtains etc.
- The rest of clearances required to maintain are indicated on the
following figure:
Position and fix the brackets at the correct
distance from the floor. It is possible to use
the radiator as measuring unit by positioning
it on two polyester package elements and
placing two supports above as indicated on
the figure:
- The studs and screws to attach the
supports are in the accessories bag.
- Hang the unit on the hooks of the
brackets.
- By turning the screw the metallic
square will go downwards, retaining the
heater. Repeat this on the other bracket.
Closest
object
to the
left end
Minimum
15cm
Minimum 10cm
12
Shelf
Minimum 15cm
Closest
object
to the
right end
Minimum 25cm
Control panel side
Mark the fixing points on the
wall using a pencil through the
two fixing holes in the square
brackets and perform
corresponding bores.
Advertisement
Table of Contents
