Setting The Time - Gabarron Elnur INGENIUM Series Installation Instructions & User Manual

Wifi thermal radiators

Hide thumbs

Table Of Contents

Table of Contents

3.1. On/Off

Once the heater is connected to a main supply you can turn the heater ON by switching the main ON/OFF switch

positioned at the rear right side of the heater as shown above.

3.2. Setting The Time

We start by first setting the Day and Time.

3.2.1 You can do this by Press & Holding the Config/

Prog. button until the following is shown. Press &

Release the Config/Prog button 7 times again to

advance through the 7th days programming.

0:00

3.2.3. Now the hours start to flash. Press the "+" and "-"

button until you reach the correct time (hour) and Press

the OK/Mode button.

0 :00

0 0

:00

0:00

If the device is associated with a G-Control Hub, the adjustment of time is removed and the time in the G-Control

Hub is configured in the heater automatically.

0:00

3.3. Programming

Select Auto Mode. Within this mode, the setpoint temperature varies according to the weekly schedule setup in the

0:00

unit. Default programming is: Comfort: 07:00 to 22:00 / Eco: 00:00 to 07:00 & 22:00 to 00:00.

3.3.1 Press & Hold the Config/Prog. button until the following is shown. The first segment will start to flash.

By pressing the OK/Mode button you can select whether you want a Frost setting

(17°C) or Comfort setting

Note: These temperatures can be changed later without adjusting the times.