Temperature Levels; Manual Override - Gabarron Elnur INGENIUM Series Installation Instructions & User Manual

3.3.2 Once you've gone through all the time intervals for day 1, you will automatically start on day 2. Repeat the
above steps until you go through all 7 days. If you do not desire to modify the programming of a specific day,
use the Config/Prog button to advance to the next day programming. Once you have configured the desired
programming, press Config/Prog button to exit programming.
0:00
3.3.3 After going through all the days, the display will show and start to run the program and will flash between
the set temperature for the current day, time interval and the word Pro to indicate the heater is running the
set program.
21.0C
AUTO

3.4. Temperature Levels

In the AUTO mode, you can temporarily change the set temperature for the time period. You can increase or
decrease this temperature simply by pressing the "+" or "-" buttons. Once the time period finishes, the temperature
will revert back to the programmed set temperature.
You can modify the set temperatures within the program permanently too, to do this, Press & Release the
Config/Prog. button until the display shows the flashing temperature symbol
0:00
Now press the OK/Mode button to select the temperature
you want to change, COMFORT or ECONOMIC, and use the "+" or "-" button to select the desired temperature.
0 0 :00
RF
It is possible to exit of temperature level configuration by pressing the Config/Prog button at any time.

3.5. Manual Override

In manual mode, the heater will maintain the temperature set point and will ignore the pre-set program.
By default, the initial temperature set point is 19°C.
3.5.1 To modify the temperature set point, Press the "+" or "-" button until the desired temperature is shown.
0:00
The heater will now cycle on and off and maintain this temperature setting. If the room temperature goes below
the set temperature, then the heaters element will turn on and the symbol
temperature is higher than the set temperature, then the heaters element won't turn on and the heating symbol
won't be displayed.
Elnur powered by Gabarrón | INGENIUM WIFI Thermal Radiators | Installation Guide
0:00
0:00
21.0C
21.0C
AUTO
AUTO
AUTO
1 1
0:00
COMFORT: Recommended for the periods of time when the user is at home
and the maximum comfort is required. Default value 19ºC.
ECONOMIC: Recommended for nights and small away periods of time.
0:00 00
Default value 17ºC.
FROST PROTECTION: Recommended for long away periods of time.
Default value 5ºC.
0:00
9:00
21.0C
AUTO
Pro
Pro
AUTO
AUTO
will be shown. If the room
AUTO
Pro
Pro
6